HOW TO INSTALL VINYL DECALS AND LETTERING

Below are the steps to install vinyl decals and lettering on your car, window, or other smooth clean surface.

1. CLEAN YOUR SURFACE

Clean the window or surface you are applying the decal. Use a mild detergent or rubbing alcohol.
Then, allow the surface to dry.

2. RUB THE SURFACE OF YOUR DECAL

Lay the decal down and rub over the graphic/surface with a squeegee or credit card. This step is essential
to make sure all the pieces peel up with the transfer tape.

3. PEEL OFF BACKING FROM DECAL

Flip over and carefully peel off the backing from the decal and transfer tape. If any part of the graphic is not attaching to the transfer tape, lay that part back down and press over the backing with your finger or credit card to get it to stick. Then peel the backing up again.

4. APPLY DECAL TO YOUR CLEAN SMOOTH SURFACE

Place your decal on your clean and dry surface. Use your squeegee or credit card to rub and smooth the decal onto the surface. Work from the center of the decal to the outside.

5. REMOVE THE TRANSFER TAPE

Peel off the transfer tape starting from the corner. Only the decal should remain.